Thanks, I'll keep that in mind. I noticed on the CX we have, that the
cranks on it are steel (I assume that's the "Torker Cotterless Cranks"
on the webpage?) and then they also have the United crank arms that are
steel. Would the steel ones be stronger than the high-quality alloy?
I'm not too concerned about the weight. And I would prefer cranks that
didn't sweep out- I have problems with severe wheel weaving when going
up grades, and I assume that would make it worse.
Also, it mentions on the webpage that you can use Coker crank arms, and
says see them, but I don't see a listing for them.
And I did get the crank arm swapped out just now, so hopefully, I'm
good to go again.
--
StephenH
------------------------------------------------------------------------
StephenH's Profile: http://www.unicyclist.com/profile/16659
View this thread: http://www.unicyclist.com/thread/71076
Posted Via Usenet.com Premium Usenet Newsgroup Services
----------------------------------------------------------
http://www.usenet.com
|
